How to setup argus as a interface error alarm ?
Mr. James W. Laferriere
babydr at baby-dragons.com
Sat Feb 9 22:20:03 EST 2008
Hello RayC , Below works like a charm . Thank you . JimL
On Wed, 6 Feb 2008, RayC wrote:
> Mr. James W. Laferriere wrote:
>> Hello All ,
>> I am attempting to setup argus to allow me to monitor 'interface
>> errors' . But every time I get an error & identify the cause & correct it
>> . Without rebooting the device (ie: cisco switch/router) . I have to edit
>> the config file to set an 'expect: 1' or whatever the value is . Is there
>> a method to say 'if this counter increases alarm' ?
>>
>> Tia , JimL
> This works for me on my C2801s. Try:
>
> Group "Errors-F0/0-LAN" {
> community: private
> details: drawgrid: yes
> graph: yes
> hostname: 10.192.8.1
> Group "Errors-IN" {
> info: Errors-F0/0-LAN IN
> title: Errors-F0/0-LAN IN
> ylabel: Errors INPUT
> Service UDP/SNMP {
> calc: ave-rate-bits
> label: Errors-IN
> maxvalue: 10
> messagedn: Errors-F0/0-LAN INPUT EXCEEDED
> messageup: Errors-F0/0-LAN INPUT Normal
> note: oid: ifInErrors.1
> }
> }
>
--
+------------------------------------------------------------------+
| James W. Laferriere | System Techniques | Give me VMS |
| Network&System Engineer | 2133 McCullam Ave | Give me Linux |
| babydr at baby-dragons.com | Fairbanks, AK. 99701 | only on AXP |
+------------------------------------------------------------------+
More information about the Arguslist
mailing list